卷簾門不斷發展應用到大型企業超市、商場、地下車庫、廠房及其他人員進行密集的場所，難免會遇到學習一些小問題需要我們解決，濟南卷簾門廠認為查看問題時先看卷簾門有沒有施加作用。

Rolling shutter doors have been continuously developed and applied to large enterprise supermarkets, shopping malls, underground garages, workshops and other places where people are concentrated. It is inevitable that we will encounter some small problems in learning and need to solve them. Jinan Rolling shutter door factory thinks that when checking the problems, we should first see if the rolling shutter doors have any effect.

檢查電源，看的卷簾門，具有電源斷路器，如果沒有電，應檢查電源線部分。如果上電時，快門控制箱應該是綠色的電源指示燈“常亮.”如果指示燈不亮，此時我們檢查變壓器（變壓器270歐姆電阻器）的控制箱內部被燃燒。

Check the power supply. The rolling shutter door is equipped with a power circuit breaker. If there is no power, check the power cord. If the shutter control box is powered on, the green power indicator light should be "normally on". If the indicator light is not on, we should check that the control box of the transformer (270 ohm resistor of the transformer) is burned inside.

如果電源指示燈閃爍綠色，表示電源部分可以是淘汰，如果條目具有可能性來控制備用電源箱板沒有電力短缺燒毀;還可以按住電源板和備電源板被燒毀。

If the power indicator flashes green, it means that the power part can be eliminated. If the entry has the possibility to control that the standby power box board is not burned due to power shortage; You can also press and hold the power board and standby power board to burn.

此外在安裝時，先在需要安裝的門框框口位置畫出線，然后找工作人員設計出合適的卷簾門，先把卷簾門的門框固定，這里要先拆掉門框下部的固定板。安裝卷簾門扇主體門扇。一定要保證卷簾門與墻體結成整體，封閉性要做好，再粉刷洞口及墻體。粉刷完畢后，門縫應均勻平整，開啟卷簾門應該自由輕便，不得有過緊、過松和反彈現象。

In addition, during the installation, draw a line at the door frame opening to be installed first, and then ask the staff to design a suitable rolling shutter door. First fix the door frame of the rolling shutter door. Here, remove the fixing plate at the lower part of the door frame. Install the main door leaf of roller shutter door leaf. Make sure that the rolling shutter door and the wall form a whole, and the sealing must be done well before painting the hole and wall. After painting, the door seam shall be even and smooth, and the rolling shutter door shall be free and easy to open, without too tight, too loose and rebound.

要保持軌道運行暢通，及時清理卷簾門的軌道，保持內部清潔，卷簾門電機和傳動鏈條要經常加注潤滑劑，檢查控制箱內器件和開關控制盒，緊固接線端口，緊固螺絲等，清潔控制箱內、表面和按鈕上的灰塵污物，防止按鈕卡住而不能反彈。在卷簾門的使用過程中，要盡量保持控制器和電壓的穩定，禁止安裝在潮濕的環境，如若發現門體上有電線纏繞、打結等應及時處理。

Keep the track running smoothly, clean the track of the roller shutter door in time, and keep the interior clean. The motor and drive chain of the roller shutter door shall be regularly filled with lubricant, check the components in the control box and the switch control box, fasten the wiring port, fasten the screws, etc., clean the dust and dirt in the control box, the surface and the buttons, and prevent the buttons from sticking and not rebounding. During the use of rolling shutter door, the controller and voltage shall be kept stable as far as possible, and it is prohibited to install it in a damp environment. In case of wire winding or knotting on the door body, it shall be handled in a timely manner.

卷簾門可以通過遙控進行控制，開關比較方便，對于存儲物品來說是比較安全的一種門，而且可以方便的安裝在任何適當的地方。您有需求可以隨時來我們網站http://www.shaulmediation.com進行咨詢了解！

The roller shutter door can be controlled by remote control. It is convenient to open and close. It is a safe door for storing goods and can be conveniently installed in any appropriate place. You can come to our website anytime you need http://www.shaulmediation.com Ask about it!