<p id="ttrrv"><cite id="ttrrv"></cite></p>
<track id="ttrrv"><strike id="ttrrv"></strike></track>

<pre id="ttrrv"><mark id="ttrrv"></mark></pre>
    <pre id="ttrrv"><del id="ttrrv"></del></pre><p id="ttrrv"></p>
    <pre id="ttrrv"></pre>

      <noframes id="ttrrv"><del id="ttrrv"><b id="ttrrv"></b></del>
            <p id="ttrrv"></p><p id="ttrrv"></p><p id="ttrrv"></p>

            歡迎光臨濟南市天橋區昌達卷簾門加工部官網!

            聯系我們 收藏本站 在線留言

            新聞資訊

            首頁>>新聞資訊>>防火卷簾門二步降怎么調?
            新聞資訊
            聯系我們
            濟南市天橋區昌達卷簾門加工部

            聯系人:劉經理

            電話:15953131568

            網址:http://www.shaulmediation.com

            地址:濟南市天橋區金牛建材市場

            防火卷簾門二步降怎么調?

            來源:http://www.shaulmediation.com 日期:2022-10-22 發布人:hongshun
            當發生火災時,防火卷簾工能有效的隔離火勢的蔓延。那么防火卷簾門二步降怎么調呢?下面濟南卷簾門廠小編為您講一講相關內容吧。
            In case of fire, the fire shutter worker can effectively isolate the spread of fire. Then how to adjust the two-step fire shutter door? Now let's talk about the relevant content for you.
            1、連電源,按下按鈕盒上的"上升”鍵,使卷簾升到頂部,再關閉電源。
            1. Connect the power supply, press the "Up" button on the button box to raise the roller shutter to the top, and then turn off the power supply.
            2、將SW2劃到"ON"位,開啟電源。
            2. Switch SW2 to "ON" position and turn on the power.
            3、按“下降”鍵,讓卷簾下滑,當下滑到中間位置時,按“停止"鍵,卷希停止并記錄頂部到至中間位的時長。
            3. Press the "Down" key to let the roller shutter slide down. When it slides to the middle position, press the "Stop" key to stop the winding and record the time from the top to the middle position.
            4、按“下降”鍵,讓卷簾下滑到底部。
            4. Press the "Down" key to let the roller shutter slide to the bottom.
            5、按“上升”鍵,卷簾上移到中間位置,按“停止”鍵,卷簾停止并記錄底部到中間位的時長。
            5. Press the "Up" key to move the roller shutter up to the middle position, and press the "Stop" key to stop the roller shutter and record the duration from the bottom to the middle position.
            6.再次按“上開”鍵,讓卷簾上移到頂部,按下降”鍵。不當下降到中間位置時,按“停止”鍵,卷簾停止,并記錄從頂部到中間位的時長。
            6. Press the "Up Open" key again to move the roller shutter up to the top, and press the "Down" key. When it is improperly lowered to the middle position, press the "Stop" key to stop the roller shutter, and record the time from the top to the middle position.
            濟南卷簾門廠
            7.后關閉電源,將SW2劃到“OFF位,然后打開電源,讓控制器進入運行狀態即可。
            7. Turn off the power supply, switch SW2 to "OFF", then turn on the power supply, and let the controller enter the operating state.
            防火卷簾門一步降和二步降區別:
            Difference between one-step and two-step fire rolling shutter doors:
            防火卷簾門的作用一般用于防火隔離和人員疏散,若防火只有防火警報器,沒有設置人工通道的,可以使用一步降,將火勢隔離開來。防火卷簾門門一般都有配置煙感和溫感器,當煙感器在發出報警時,報警主機在接收到報警的信號之后,會給卷簾門發生一步降的指令,降距在地面1.8米位置。
            The function of the fire rolling shutter door is generally used for fire isolation and personnel evacuation. If there is only a fire alarm for fire prevention and there is no manual passage, one-step fire control can be used to isolate the fire. Fireproof rolling shutter doors are generally equipped with smoke detectors and temperature sensors. When the smoke detectors give an alarm, the alarm host will give the rolling shutter door a command to drop down further after receiving the alarm signal, and the drop distance is 1.8 meters above the ground.
            當溫感超過68度,溫感器報警時,報警主機接收到報警信號之后,會給卷簾工門門發出二步降(全降)的指令,避免火勢進一步的擴散和蔓延。而疏散通道的卷簾門,在發生火災時,要先進行一步降,將卷簾門下降到中間位置停止,以便于人員疏散,等接收到溫感器發生的報警信號時,能進行二步降。關注我們http://www.shaulmediation.com,了解更多相關事項!
            When the temperature sensor exceeds 68 degrees and the temperature sensor alarms, the alarm host will send a two-step lowering (full lowering) command to the shutter door after receiving the alarm signal, so as to avoid further spread and spread of the fire. In case of fire, the shutter door of the evacuation exit shall be lowered to the middle position to stop, so as to facilitate personnel evacuation. When the alarm signal from the temperature sensor is received, it can be lowered in two steps. Follow us http://www.shaulmediation.com , learn more about it!

            推薦閱讀/ Recommended reading

            鋁合金卷簾門作為比較常見的產品,自然也會出現問題,比較常見的問題就是門體運轉速度下降或干脆不動了,而造成這些毛病的原因是有很多的。

            卷簾門的使用優勢及遇到問題該如何解決 2022-12-20
            查看問題時先看卷簾門有沒有施加作用 2022-12-17
            防火卷簾門維修常見故障及處置方式 2022-12-14
            不銹鋼卷簾門的幾種常見材質 2022-12-13

            【本站圖片均由網站所有方提供,部分圖片來源于網絡,如無意中侵犯了某媒體或個人的知識產權,請來信或來電告之,本網站將立即刪除?!?/p>

            • 宏順卷簾門
            欧美日韩国产

            <p id="ttrrv"><cite id="ttrrv"></cite></p>
            <track id="ttrrv"><strike id="ttrrv"></strike></track>

            <pre id="ttrrv"><mark id="ttrrv"></mark></pre>
              <pre id="ttrrv"><del id="ttrrv"></del></pre><p id="ttrrv"></p>
              <pre id="ttrrv"></pre>

                <noframes id="ttrrv"><del id="ttrrv"><b id="ttrrv"></b></del>
                      <p id="ttrrv"></p><p id="ttrrv"></p><p id="ttrrv"></p>