<p id="ttrrv"><cite id="ttrrv"></cite></p>
<track id="ttrrv"><strike id="ttrrv"></strike></track>

<pre id="ttrrv"><mark id="ttrrv"></mark></pre>
    <pre id="ttrrv"><del id="ttrrv"></del></pre><p id="ttrrv"></p>
    <pre id="ttrrv"></pre>

      <noframes id="ttrrv"><del id="ttrrv"><b id="ttrrv"></b></del>
            <p id="ttrrv"></p><p id="ttrrv"></p><p id="ttrrv"></p>

            歡迎光臨濟南市天橋區昌達卷簾門加工部官網!

            聯系我們 收藏本站 在線留言

            新聞資訊

            首頁>>新聞資訊>>安裝卷簾門窗常見的問題?
            新聞資訊
            聯系我們
            濟南市天橋區昌達卷簾門加工部

            聯系人:劉經理

            電話:15953131568

            網址:http://www.shaulmediation.com

            地址:濟南市天橋區金牛建材市場

            安裝卷簾門窗常見的問題?

            來源:http://www.shaulmediation.com 日期:2021-07-15 發布人:hongshun
            卷簾的上部頂板上,都要配置溫感和煙感探頭,側墻上要安裝三臺強弱電控制設備,門的兩側還要安裝兩個控制按鈕,所有的管路都要敷設在結構混凝土的墻體和頂板內。因此總包單位在組織各會審圖紙之前,工程的建設單位、設計單位和工程總承包與地方消防管理的政府部門應該再次協商,把卷簾門的位置確定好。因為如果位置移動,要影響所有暗裝管路的追位,處理的難度大。審圖過程中要注意現場施工過程中經常出現的幾種問題:
            The upper roof of the rolling shutter should be equipped with temperature and smoke sensors, three strong and weak current control devices should be installed on the side wall, two control buttons should be installed on both sides of the door, and all pipelines should be laid in the wall and roof of the structural concrete. Therefore, before the general contractor organizes all specialties to review the drawings, the construction unit, the design unit, the general contractor and the local government department of fire management should negotiate again to determine the location of the rolling shutter door. Because if the position is moved, it will affect the tracking of all concealed pipelines, which is very difficult to deal with. In the process of drawing review, we should pay attention to several problems that often appear in the process of on-site construction
                               濟南卷簾門廠
            (1)建筑結構設計的位置同電氣設計的位置不在同一座標位置上,斜坡道進出口的卷簾門建筑圖紙設計在斜坡道上部,電氣圖紙設計在斜坡道的下部,有的建筑圖紙上設計是兩樘而電氣圖紙上是一樘等,然后都是由電氣改管追位。
            (1) The position of architectural structure design is not in the same coordinate position as that of electrical design. The architectural drawing of rolling shutter door at the entrance and exit of ramp is designed at the upper part of ramp, and the electrical drawing is designed at the lower part of ramp. Some architectural drawings are designed in two parts, while the electrical drawing is designed in one part, and then the electrical specialty changes the management and position.
            (2)卷簾門滾筒超長,結構工程完成以后進不去,然后只能采取拆門或鋸斷主軸等被動措施來處理,如果在審圖能及時發現此類問題,留好通道則完全可以避免。
            (2) The roller of the rolling shutter door is too long to enter after the completion of the structural engineering, and then passive measures such as dismantling the door or sawing off the main shaft can only be taken to deal with it. If such problems can be found in time during the drawing review, the channel can be completely avoided.

            推薦閱讀/ Recommended reading

            鋁合金卷簾門作為比較常見的產品,自然也會出現問題,比較常見的問題就是門體運轉速度下降或干脆不動了,而造成這些毛病的原因是有很多的。

            卷簾門的使用優勢及遇到問題該如何解決 2022-12-20
            查看問題時先看卷簾門有沒有施加作用 2022-12-17
            防火卷簾門維修常見故障及處置方式 2022-12-14
            不銹鋼卷簾門的幾種常見材質 2022-12-13

            【本站圖片均由網站所有方提供,部分圖片來源于網絡,如無意中侵犯了某媒體或個人的知識產權,請來信或來電告之,本網站將立即刪除?!?/p>

            • 宏順卷簾門
            欧美日韩国产

            <p id="ttrrv"><cite id="ttrrv"></cite></p>
            <track id="ttrrv"><strike id="ttrrv"></strike></track>

            <pre id="ttrrv"><mark id="ttrrv"></mark></pre>
              <pre id="ttrrv"><del id="ttrrv"></del></pre><p id="ttrrv"></p>
              <pre id="ttrrv"></pre>

                <noframes id="ttrrv"><del id="ttrrv"><b id="ttrrv"></b></del>
                      <p id="ttrrv"></p><p id="ttrrv"></p><p id="ttrrv"></p>